|
A variety of sizes
and types is available, including bottom porting for very high viscosity
liquids and top porting for low to medium viscosities.
Drop in bottle reservoir with viewing glass, right front. Flip top pressure
tanks, left and center front. Removable lid tank, right rear.
Choose from links below to view detail.
An "open top"
style is used if liners are required to prevent the material from making
contact with the sides of the container or if the fluid requires an
agitator.
Simply hook up the vessel to a clean compressed
air source. As always, set the air source low. Shop air,
typically around 100-120 PSI, may be far too much for the material you are
dispensing.
For a typical valve
setup, click here.
If you are setting up in an area without air, consider our
portable air source, the Silent Benchtop
Compressor. It will generally satisfy the needs of a small benchtop
dispenser and 1 liter or 1 pound pressure pot. Consult us for larger
compressors if you need a bigger tank.
With the air supply feed set on low, and the material
feed line connected from the pressure pot to the valve, the air lines from
the controller to the valve secure, set the controller switch to manual and
recheck the connections.
Slowly bring up
the pressure as you experiment with the controller in manual mode before
using time/pressure settings.
When you are satisfied the air and feed
lines are secured properly, fit the syringe or valve to the adapter head or
valve line and begin dispensing.
|
